When needing common parts for ukes it helps to make a bunch of them at once.
These Kasha tenor bridges will be ready when needed.
I cut fret slots in ten tenor boards but needed Yin/Yangs in only a few so it was off to Bay Engraving for the laser holes.
And now to install the Yin of Holly and the Yang of Ebony--or is it the other way around?
Just a little glue in the hole, insert the pieces and the job is done.
Stu Fuchs gets the credit for the frequent requests I get for Yin/Yangs in the first fret, just like his uke.
